Coleman Powermate Manual Transfer Switch 10 Circuit 30amp Surface Mount

Description

Easy to install and operate, connects portable generator to residential load center.  Allows manual transfer of individual loads to prevent overloading generator.   Each individual circuit can be transferred separately and only as needed.   Now required by Article 702.6 of the 2002 National Electric Code to prevent inadvertent backfeeding of electric power from generator into utility system which can be a safety hazard.
Up to 10 single-pole 120 volt circuits or 5 double-pole 240 volt circuits, 60 amps maximum combined load at 125 volts or 30 amps maximum combined load at 250 volts.   Each circuit provided with non-defeatable (break-before-make) double throw switch protected with a resettable circuit breaker.  Factory configured with ten 15 amp breakers.
Twist lock male
L1430P
power inlet receptacle for cable connection to generator, 7500 watt maximum. Dual watt meters provided for balancing generator load.  Indicator light controlled by rocker switch provided to show when utility power is restored.  Flexible conduit is pre-wired for easy connection to existing residential load center panel.  Installs in less than an hour, without pulling the electric meter or installing a sub-panel.  Suitable only for circuits protected with up to 20 amp breakers or fuses.  UL listed.  NEMA 1 indoor surface mount enclosure.  Made in USA.
Specifications
Total Capacity
7500 watts, 30 amps
Single Pole Circuits - 120VAC
(6) 15 amp
Double Pole Circuits - 240VAC
(2) 15 amp with handle tie
Generator Connection
NEMA
L1430P
male inlet plug-in
Generator Load Watt Meters
Yes
Enclosure Type
indoor surface mounted
Convenience Receptacle
No
UL Short Circuit Withstand Rating
1,000 amps